器件名称: ELM310P
功能描述: STEPPER MOTOR CONTROLLER
文件大小: 37.74KB 共5页
简 介:ELM310 Stepper Motor Controller
Description
The ELM310 is an interface circuit for use between high speed logic outputs and four phase stepper motor driver circuits. By suitably debouncing mechanical switches, the circuit could also be used for manually controlling stepper motors as well. This circuit supports two popular modes of operation, and can be switched between the two ‘on the fly’. The full-step, or single phase wave mode, as it is sometimes called, is entered into at powerup. This mode provides sequential single phase output signals for driving a variety of circuits with only one output active at any one time. The other mode that the ELM310 supports is the half-step. In this case, there are eight distinct output patterns as opposed to the four for the full-step mode. For each step, the pattern alternates between a single winding being energized, and two adjacent windings, providing eight steps in total.
Features
Low power CMOS design - typically 1mA at 5V Wide supply range - 3.0 to 5.5 volt operation Two inputs control both mode and motion No external timing components Completely static operation - will maintain a step position indefinitely High current drive outputs - up to 25 mA Both half and full stepping supported Very high speed - up to 25000 steps per second
Connection Diagram PDIP and SOIC (top view)
VDD
1 2 3 4
8 7 6 5
VSS B C D
Applications
Stepper motor drive logic Process sequencing Sequential left/right LED driver
A Dir Step
Block Dia……
